Ultrasonic sensor UC4000-30GM-IUEP-IO-V15
Brand: Pepperl+Fuchs
Code: UC4000-30GM-IUEP-IO-V15
Single head system, IO-Link interface for service and process data, Programmable via DTM with PACTWARE, Switch output and analog output, Series: -30GM, Operating voltage: 10 ... 30 V DC , ripple 10 %SS
15 ... 30 V voltage output, Interface type: IO-Link, Output type: 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected
Current output 4 mA ... 20 mA or
voltage output 0 V ... 10 V configurable, UL approval: cULus Listed, Class 2 Power Source
Datasheet excerpt: Technical data of UC4000-30GM-IUEP-IO-V15
Product Description |
---|
Single head system |
General specifications | ||
---|---|---|
Sensing range | 200 ... 4000 mm | |
Adjustment range | 240 ... 4000 mm | |
Dead band | 0 ... 200 mm | |
Standard target plate | 100 mm x 100 mm | |
Transducer frequency | approx. 85 kHz | |
Response delay | minimum : 115 ms factory setting: 225 ms | |
Memory | ||
Non-volatile memory | EEPROM | |
Write cycles | 100000 | |
Indicators/operating means | ||
LED green | solid: Power on flashing: Standby mode or IO link communication | |
LED yellow 1 | solid: Object in evaluation range flashing: Learning function, object detected | |
LED yellow 2 | solid: Object in evaluation range flashing: Learning function, object detected | |
LED red | solid red: Error red, flashing: program function, object not detected | |
Electrical specifications | ||
Operating voltage | 10 ... 30 V DC , ripple 10 %SS 15 ... 30 V voltage output | |
No-load supply current | ≤ 60 mA | |
Power consumption | ≤ 1 W | |
Time delay before availability | ≤ 150 ms | |
Interface | ||
Interface type | IO-Link | |
Protocol | IO-Link V1.0 | |
Transfer rate | Acyclical: typical 54 Bit/s | |
Cycle time | min. 59.2 ms | |
Mode | COM2 (38.4 kBit/s) | |
Process data width | 16 bit | |
SIO mode support | yes | |
Input/Output | ||
Input/output type | 1 synchronization connection, bidirectional | |
0 Level | 0 ... 1 V | |
1 Level | 4 V ... UB | |
Input impedance | > 12 kΩ | |
Output rated operating current | < 12 mA | |
Pulse length | 0.5 ... 300 ms (level 1) | |
Pulse interval | ≥ 62 ms (level 0) | |
Synchronization frequency | ||
Common mode operation | ≤ 16 Hz | |
Multiplex operation | ≤ 17 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) | |
Output | ||
Output type | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected Current output 4 mA ... 20 mA or voltage output 0 V ... 10 V configurable | |
Rated operating current | 200 mA , short-circuit/overload protected | |
Voltage drop | ≤ 2.5 V | |
Resolution | current output: evaluation range [mm]/3200 but ≥ 0.35 mm voltage output: evaluation range [mm]/4000 but ≥ 0.35 mm | |
Deviation of the characteristic curve | ≤ 0.2 % of full-scale value | |
Repeat accuracy | ≤ 0.1 % of full-scale value | |
Switching frequency | ≤ 2 Hz | |
Range hysteresis | 1 % of the adjusted operating range (default settings), programmable | |
Load impedance | current output: ≤ 300 Ohm voltage output: ≥ 1000 Ohm | |
Temperature influence | ≤ 1.5 % from full-scale value (with temperature compensation) ≤ 0.2 %/K (without temperature compensation) | |
Compliance with standards and directives | ||
Standard conformity | ||
Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003 | |
Approvals and certificates | ||
UL approval | cULus Listed, Class 2 Power Source | |
CCC approval | CCC approval / marking not required for products rated ≤36 V | |
Ambient conditions | ||
Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) | |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
Mechanical specifications | ||
Connection type | Connector plug M12 x 1 , 5-pin | |
Housing diameter | 40 mm | |
Degree of protection | IP67 | |
Material | ||
Housing | Stainless steel 1.4305 / AISI 303 TPU Polyamides | |
Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam | |
Mass | 95 g | |
Factory settings | ||
Output 1 | near switch point: 240 mm far switch point: 4000 mm Output mode: Window mode output behavior: NO contact | |
Output 2 | near limit: 500 mm far limit: 2000 mm Output mode: rising ramp output behavior: Current output 4 mA ... 20 mA | |
Beam width | wide |
Classifications
System | Classcode |
---|---|
ECLASS 13.0 | 27272803 |
ECLASS 12.0 | 27272803 |
ECLASS 11.0 | 27272803 |
ECLASS 10.0.1 | 27272803 |
ECLASS 9.0 | 27272803 |
ECLASS 8.0 | 27272803 |
ECLASS 5.1 | 27272803 |
ETIM 9.0 | EC001849 |
ETIM 8.0 | EC001849 |
ETIM 7.0 | EC001849 |
ETIM 6.0 | EC001849 |
ETIM 5.0 | EC001849 |
UNSPSC 12.1 | 41111960 |
Check out any spare parts and components from the Pepperl+Fuchs catalog!
Do you want to order a Ultrasonic sensor UC4000-30GM-IUEP-IO-V15 with code: UC4000-30GM-IUEP-IO-V15?
Leave your request on our website for immediate assistance!