Ultrasonic sensor UC500-L2M-U-T-2M
Brand: Pepperl+Fuchs
Code: UC500-L2M-U-T-2M
Single head system, Extended temperature range, Cable connection, Rugged metal base, Series: -L2, Operating voltage: 12 ... 30 V DC , ripple 10 %SS, Interface type: Serial interface (programming adapter required)
9600 BPS, no parity, 8 data bits, 1 stop bit, Output type: 1 analog output 0 ... 10 V, UL approval: cULus Listed, General Purpose, CCC approval: CCC approval / marking not required for products rated ≤36 V, Connection type: cable , 5-pin, Housing: PA-GF35
Datasheet excerpt: Technical data of UC500-L2M-U-T-2M
| Product Description |
|---|
| Single head system |
| General specifications | ||
|---|---|---|
| Sensing range | 35 ... 500 mm | |
| Adjustment range | 50 ... 500 mm | |
| Dead band | 0 ... 35 mm | |
| Standard target plate | 100 mm x 100 mm | |
| Transducer frequency | approx. 380 kHz | |
| Nominal ratings | ||
| Response delay | minimum: 20 ms factory setting: 145 ms | |
| Time delay before availability | ≤ 1600 ms | |
| Indicators/operating means | ||
| LED green | Operating display | |
| LED yellow | object in evaluation range | |
| LED red | error | |
| Electrical specifications | ||
| Operating voltage | 12 ... 30 V DC , ripple 10 %SS | |
| No-load supply current | ≤ 50 mA | |
| Interface | ||
| Interface type | Serial interface (programming adapter required) 9600 BPS, no parity, 8 data bits, 1 stop bit | |
| Input/Output | ||
| Input/output type | 1 synchronization connection, bidirectional | |
| 0 Level | 0 ... 1 V | |
| 1 Level | 4 V ... UB | |
| Input impedance | > 12 kΩ | |
| Output rated operating current | < 12 mA | |
| Pulse length | 0.5 ... 300 ms (level 1) | |
| Pulse interval | ≥ 14 ms (level 0) | |
| Synchronization frequency | ||
| Common mode operation | ≤ 70 Hz | |
| Multiplex operation | ≤ 90 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) | |
| Input | ||
| Input type | 1 program input | |
| Level (evaluation limit 1) | 0 ... 1 V | |
| Level (evaluation limit 2) | 4 V ... UB | |
| Input impedance | > 12 kΩ | |
| Pulse length | 2 ... 10 s | |
| Output | ||
| Output type | 1 analog output 0 ... 10 V | |
| Resolution | evaluation range [mm]/4000, but ≥ 0.05 mm | |
| Deviation of the characteristic curve | ≤ 0.2 % of full-scale value | |
| Repeat accuracy | ≤ 0.1 % of full-scale value | |
| Load impedance | ≥ 500 Ohm | |
| Temperature influence | ≤ 1.5 % of full-scale value | |
| Compliance with standards and directives | ||
| Standard conformity | ||
| Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003 | |
| Approvals and certificates | ||
| UL approval | cULus Listed, General Purpose | |
| CCC approval | CCC approval / marking not required for products rated ≤36 V | |
| Ambient conditions | ||
| Ambient temperature | -40 ... 70 °C (-40 ... 158 °F) | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Mechanical specifications | ||
| Connection type | cable , 5-pin | |
| Degree of protection | IP67 | |
| Material | ||
| Housing | PA-GF35 | |
| Cable | PUR | |
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam | |
| Cable | ||
| Sheath diameter | 7.25 mm | |
| Bending radius | > 37.3 mm , fixed > 74.7 mm , moving | |
| Core cross section | 5 x 0.82 mm2 | |
| Length | 2 m | |
| Mass | 345 g | |
| Factory settings | ||
| Output | near limit: 50 mm far limit: 500 mm Output mode: rising ramp | |
| Beam width | wide | |
| Evaluation procedure | low-pass behavior | |
| General information | ||
| Supplementary information | Switch settings of the external programming adapter: "output load": pull-down "output logic": noninv | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27272803 |
| ECLASS 12.0 | 27272803 |
| ECLASS 11.0 | 27272803 |
| ECLASS 10.0.1 | 27272803 |
| ECLASS 9.0 | 27272803 |
| ECLASS 8.0 | 27272803 |
| ECLASS 5.1 | 27272803 |
| ETIM 9.0 | EC001849 |
| ETIM 8.0 | EC001849 |
| ETIM 7.0 | EC001849 |
| ETIM 6.0 | EC001849 |
| ETIM 5.0 | EC001849 |
| UNSPSC 12.1 | 41111960 |
Check out any spare parts and components from the Pepperl+Fuchs catalog!
Do you want to order a Ultrasonic sensor UC500-L2M-U-T-2M with code: UC500-L2M-U-T-2M?
Leave your request on our website for immediate assistance!
